Rev Compatible Axle Mount

thingiverse

This is based on the REV-41-1317 (http://www.revrobotics.com/rev-41-1317). It's designed so that when attached to the bottom of a piece of 15mm extrusion, the axle sits at the same height as it would if using a REV-41-1303 (http://www.revrobotics.com/rev-41-1303) mounted to the side of the extrusion. The main goal is to modify the design of the Rev Robotics minibot (http://www.revrobotics.com/rev-45-1171/) so that it lies flat. By its very nature, the front axle is positioned lower than the rear axle. Using this part as a replacement for a REV-41-1317 allows the front axle to be mounted at the same height as the rear axle. Rev Robotics refers to this component as a 15MM Bearing Pillow Block.