Retroid Pocket 3 full size console grip - BeefyGrip w/ Extra Beef

thingiverse

Okay, so I'm not very good at creating/editing models but I did what I could. I wanted to print the BeefyGrip in TPU but the center was just too flimsy to and didn't do a very good job of holding in place. I added some 'beef' to the center area. This did remove the inserts from the original. Other changes: Reduced the size to 99.3% from the original, grips firmly. Rotated to fit on smaller beds with a raft. Infill 100%, Printing less than 60% infill will likely not hold the console in place. I used the Overture TPU High Speed Filament on an Ender 3 Temp 220/60 https://a.co/d/hFhR2VR