RETRO CAMERA FLOWERPOT 3D print model

cgtrader

This is My Unique Vintage Camera Flower Pot Design.\nGet Creative with Your Own Paint Jobs! \nTurn This Design into Multiple Sizes and Bring Cozy Touches to Your Home!\n\nCreating This Model Took 4 Hours of Hard Work.\nThe Model's Specifications Include a Low-Poly Count of Just 30,000 Triangles! :)\nThe Total Number of Points Is 35,000. The Entire Model is Made Up of 11 Interconnected Parts.\nGet Ready to Print – No Supports Needed!\n\nCREALITY CR-10 Recommended Print Settings Below: For Printing the Large Base Pot: 15 CM in Height 0.2mm (200 Micron) Layer Thickness Recommended Print Settings: %20 infill is Ideal Use 60 Degrees for Bed Heat and 200 Degrees for the Nozzle – Don't Forget! Estimated Print Time: 12 Hours. The Following Parts Can Be Printed Using Different Settings: Print Smaller Pieces at 0.1mm (100 Micron) Layer Thickness Optimize Your Infill by Printing with %30 Density. Use 60 Degrees Bed Heat and Keep Your Nozzle Temperature High – Set it to 200 Degrees. These Print Jobs Should Only Take Approximately 11 Hours Each, Adding Up to a Total of 23 Hours for All the Pieces. If You Do Decide to Paint Them Together After Assembling the Larger Component with Sandpaper – That's Entirely Your Choice! As for Finishing Touches, There is Absolutely No Need to Use Any Sandpaper or Advanced Techniques When Using 0.1mm Layer Thickness. We Would Be Delighted if You Took the Time to Create Your Own Design! Share it with us! You can stay updated about new and exciting projects on our official Instagram Page at \n@tolgaaxu\nand \n@buyucusokagi. Have Any Questions or Orders in Bulk? Please Do Not Hesitate to Get in Touch – We're Looking Forward to Your Next Message! See you next project!