Retro Alarm Clock Stand for the Google Home Mini (snap together)

prusaprinters

<p>I saw someone else that made a remix of this one that had a better fit then the original but didn't want to share the STL's so I made my own one!</p><p>Added some other improvements to like:</p><ul><li>No support needed</li><li>Legs and bell pins are separate parts that you can glue</li><li>Bells has built in support</li><li>really good fit for the home, I couldn't get mine out again :D</li></ul><p>&nbsp;</p><h3>Updates</h3><p>2019-01-18</p><p>Added<strong>main_body_v4</strong> and<strong>bell_peg_v4_wide</strong></p><p>The bell beg is a lot wider since I got reports that the earlier version could be a bit weak. This also means that the square holes in the main body need to be bigger, I guess you could use a rotary tool or just print the v4 body that matches!</p><h3>Print Settings</h3><p><strong>Printer:</strong></p><p>RepRapPro Mono Mendel</p><p><strong>Rafts:&nbsp;</strong></p><p>No</p><p><strong>Supports:</strong></p><p>No</p><p><strong>Resolution:&nbsp;</strong></p><p>0.2</p><p><strong>Infill:</strong></p><p>20%</p><p><strong>Filament:</strong></p><p>ClasOhlson PLA</p><p>White</p><p><br>&nbsp;</p><p><strong>Notes:</strong></p><p>&nbsp;</p><p>The settings all depend on your printer, I had to slow it down to half my normal speed just for the pins <i>(feet and bell)</i>, otherwise it didn't have time to cool down and looked awful!</p><p>Post-Printing =============</p><p><strong>Printing</strong></p><p>Print one of these:</p><p>* Main body * Top bar</p><p>and two each of these</p><ul><li>Bell</li><li>Foot Peg</li><li>Bell Peg</li></ul><p>As I said earlier depending on your own cooling and printer you might need to slow down the print for the pegs. I used a rim when printing them just to be sure they wouldn't fall over.</p><p><strong>Post printing</strong></p><p>Clean up the prints if needed and use a tad of super glue to attach the pins to the main body. Do a test fit first to see if you need to file the holes some _(depending on your printer)</p><p>Insert the Google home mini into the main body making sure that the charging port is at the right place. It should be a tight fit so no adhesive needed!</p><p>Attach the top bar with 2 m3 screws or just some more glue if you don't have any screws available. There is a center hole all the way through the<strong>bell peg</strong> if you want to secure it with a long m3 and acorn nut.</p><p>Attach the charging cable and loop it down through the slot in the back and you're done! Have a good nights sleep before waking up with Google! :D</p><p>&nbsp;</p><p>&nbsp;</p><p>Category: Other</p>