Retractable mobile phone holder for car

thingiverse

Mobile Phone Holder for Car with Spring Retract System! This concept has tremendous potential and can be taken to the next level with further refinement. Place your smartphone into the hook retract system effortlessly, and it will stay in place thanks to its own weight. When you lift the phone, the retract system opens up, making it easy to remove from the mount. You can attach this holder to car vents using a 3 cm wide, extremely strong clip. To create the retract system, use a pen spring. The strength of retraction depends on the length of the spring, so shorten it if it's too strong! Check out this video for a detailed explanation: https://www.youtube.com/watch?v=k3Kv712EHzc Print material: ABS Printed parts layer height: 0.1 Infill options: 100% or 40%, your choice. To assemble the holder, use a stiff to combine the stiff holders with the left and right hooks and main hook. Simply hammer it in, grease and screw together with the main body, and run up and down a few times to smooth out any bumps. Alternatively, you can sand the parts before assembly. If you print the clip and main hook with support touching the build plate, use brim or skirt for other parts. The ball mount already has built-in mesh mixer supports for the nut in the middle, so be sure to remove them to loosen the nut. Apply grease to the parts for better movement, including the stiff holders, inner circle body system, and hole where the spring is. To prevent the ball mount from moving too easily, place a small piece of rubber band inside the thread piece. Tested on a Samsung Galaxy S9 Plus with a gel case. This holder can accommodate smartphones up to 6.5 cm in width and as large as 9.5 cm in wideness. The maximum depth is 1.4 cm, but you can modify the hooks for more wideness or depth. Cheers!