Respirator Mask v2

cults3d

Summary This mask, like many others, is designed as a fall-back to proper medical equipment in case of shortage. Features: Prints in less than 6 hours No supports needed Thin enough walls so that it can be cut with scissors and adjusted to fit with a hair dryer. Optional filter cap Improved / reduced back pressure thanks to large filtration area. I make no guarantees that this mask will protect you from anything, even though that is my design intent. My main goal here is to share my design idea so it can at least be remixed or inspire someone with a better design down the road. Do your research about filtering media, and on how to clean a reusable mask. This is a remix of my previous version I designed. After using my first respirator design we found that it was difficult to breathe through the three layers of paper towels. (see remix source below) On the inhale it was too hard to breathe naturally. On the exhale the back-pressure would cause air leaks around the face seal. The larger surface area of this design reduces these issues. The mask however can still be printed in one piece. Remix from: https://www.prusaprinters.org/prints/26794-respirator-mask-for-diy-filter #3DvsCOVID19