Resistor holder

thingiverse

I'm building 40 small containers that are angled at 45 degrees, each measuring 20 by 20mm. They're 42mm deep, leaving about 8mm of resistor legs sticking out. If your printer can print at 45-degree angles without supports, you won't need to enable them. I wouldn't recommend printing this design with supports either - it's best left unsupported. The estimated printing time for this project is around 9.5 hours using a CR-10s printer and a layer height of 0.3mm. I apologize for the poor photo quality; my flash was on, which might have caused some issues. If you've managed to take a better photo, please share it with me!