ResinWash

thingiverse

This is a resin wash machine for clean UV resin prints. List of parts you will need: 1. Container 5x5'' size 2. Eight Magnets, 10mm in diameter 3. One 120 mm case fan with propellers cut off 4. One Potentiometer with 10k resistance and one turn 5. One Resistance, 470 ohms in value 6. One MOSFET channel N, type 50N06 7. One Bearing, 608zz style 8. One Female Panel Mounting Connector 9. One 12v power adapter Building instructions: - Apply glue to the top of the fan and attach the fan cap. - Place four magnets on the Magnets holder facing upwards and four magnets on the Impeller in the same way, so both parts repel each other. Attach the magnets holder to the fan cap with a screw. - Wire parts according to the included diagram. - Connect your wired parts to your printed Main parts. - Attach an oiled 608zz Bearing to the bottom of your Impeller basket. Always start the fan slowly when starting up. These parts are remixed from https://www.thingiverse.com/thing:4130767 -Impellering -Fan Cap -Magnets holder -Impellering_Top MOSFET channel N 50N06: https://www.amazon.com/-/es/10pcs-FQP50N06-50N06-MOSFET-Original/dp/B07NTZXJDD/ref=sr_1_2?__mk_es_US=%C3%85M%C3%85%C5%BD%C3%95%C3%91&dchild=1&keywords=MOSFET+N+50N06&qid=1590587558&sr=8-2 Bearing 608zz: https://www.amazon.com/-/es/Shielded-Skateboard-Bearings-Longboard-Scooters/dp/B07DZDLB3N/ref=sr_1_3?__mk_es_US=%C3%85M%C3%85%C5%BD%C3%95%C3%91&dchild=1&keywords=608zz+bearing&qid=1590587623&sr=8-3 Print settings: Rafts: No Supports: No