Resin Drip Stand for Pegboard Conversion

thingiverse

So where to start, A buddy of mine was looking to print off a resin draining stand but he wanted his to mount on a pegboard. I was unable to find a stand that i liked for a pegboard as they all looked fragile and i had already built my stand that i absolutely loved a while ago so i wanted to build off of this. I'm not sure who was the original but i used and built off of these parts: Vat/Reservoir Holder from: https://www.thingiverse.com/thing:3797686 Funnel Holder from: https://www.thingiverse.com/thing:3784926 If you already printed and built one of these stands, I built a conversion plate to convert your existing parts to support a pegboard installation. The back plate has the negative space where the 2 poles go and fits up absolutely perfectly. Specifics for each part: ººº Resin_Drip_Stand-Conversion-Funnel.stl ººº For the funnel, and is best when used with M3 screw at 12mm in length with an m3 hex nut. The hex nut fits in a recessed portion on the back so as to not protrude out the back side, which can cause the back plate to not sit flat against the wall/pegboard ººº Resin_Drip_Stand-Conversion-Vat.st lººº For the Vat/Reservoir front, same thing with the negative space but this one fits an M3x25mm screw with the M3 hex nut. Reference the image of the plates printed in gray and you see how nicely the nut fits allowing for a flush mount. You will want the screws to be as close as possible, but if the screw does protrude out past the plane a little bit, it wont prevent this from working, it will just push the bottom end out a little bit. If you haven't printed these resin drain stand parts out already, i've also included said pieces with the peg board attachments on it. Or i suppose you could print the original and use these conversions to make your stand capable of being setup multiple ways ººº Resin_Drip_Stand-Converted-Funnel.stl ººº Exactly the same as the original but with the pegs in it. ººº Resin_Drip_Stand-Converted-VatHolder.stl ººº slightly modified from the original, I made the resin holder arms stick out an additional 5mm. The original was pretty snug for my Photon Mono X, so i decided to give it just a little more space. Hope someone finds this to be useful, im sure a lot of people have printed these stands already, so if you want to dip your toes in and try a peg board, you can use up a lot less resin doing so!