Resin Curing Cylinder

thingiverse

<iframe width="560" height="315" src="https://www.youtube.com/embed/IaLU9dMY4dM" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe> This is specifically designed to cure prints from the Anycubic Photon. Any print produced by the Photon will fit seamlessly inside. I also created a small handle to hold the light I'll be using to cure my prints: A UV light, available on Amazon, fits snugly on top with corners. Designed with 0.5 cm clearance on the sides and 5 cm on top with the light for the largest possible print you could make with the Photon. Line the inside with aluminum foil (also aluminum foil tape) for reflective walls. Using a turntable with no batteries since it's solar powered, the UV light powers it, and this fits neatly on the feet. I didn't want to purchase a bucket when I have so much excess filament lying around. You can use reflective tape inside with a turntable to turn the print. However, the turntable will cause the print to be higher than what this was designed for. Keep that in mind.