Republic Cruiser from Star Wars TPM remixed engines and more

thingiverse

I added the sensor array. It was missing from the ship, and I had no idea it was gone. I also added the escape pod from David's Tantive IV. You can glue it onto the bottom of the mid section on the circles. I'll update the middle section with them as well, but I recommend building them separately. I added the whole ship without turrets to the files. This should make it easier to work with. I repaired the mid 2 modded file, as the engines were messed up. Please let me know if there are any other problems. I added a couple of new files per your request. The middle section has been updated with more detail but no turret holes. A complete engine section is also available now. I'm going to try to add the complete ship in one STL as soon as Tinkercad cooperates with me. Just added some extra details to the engines and side hatches for the middle section. Splitting the middle into two parts will use less support material. The inside engines turbines are from the Serenity model in the remix list. Now I have a version 2 of the middle section, along with a picture showing my inspiration. Added a little detail on the bottom as well. The guns will need some support and aren't friction fit, so they'll need to be glued. If you want a tight fit, try scaling up the guns a bit until they're snug. I scaled them 105% in Cura, and they fit perfectly that way. Just don't use the guns to adjust position – pull the gun out and push it back in where you want it. The cockpit gun is done, with three versions available: original with a dish, one with an armor plate on the gun, and one without any armor. I used parts from several sources for all three, and they now have dishes. I'll try to list them in the remixes soon. I added a modified version of David Bogaerts' Stand and base. It's pretty simple, and it's in scale with the ship. If you make the ship bigger, just scale the base and posts the same as the ship. There's a picture showing the position for the posts of the base. I also added longer back and front posts for the more detailed mid 2 STL. The posts are friction fit, so they may need a little sanding to get them to stay in place.