Reprap Neo Extruder Upgrade for Ninjaflex

thingiverse

I made an upgrade for my Reprap Neo extruder so that I could print with Ninjaflex, as the standard Neo Extruder wouldn't work properly with it. With this upgrade and my E3D V6 setup, I'm able to print easily using my Neo Bowden system. My Printing Settings are set like this: Rafts: None Supports: Always enabled Resolution: 0.3 millimeters Infill: 30% fill ratio I've taken a note that printing should be quite straightforward. After printing, I found out that the bearing needs an M4 screw, so I need to make sure that there is an M4 screw where the bearing will sit in place.