Replicator Power Entry/Switch Cover

thingiverse

This Thing serves as a straightforward cover to protect the original power connector and switch of the Replicator. When a power supply is installed at the base of the printer, these openings become redundant, and it makes sense to seal them off so nothing gets lodged inside (including the original power cord). This design is merely an adaptation in that I leveraged the same screw holes as the Replicator Power Cord Support Bracket, which has been in place for the past five years. If you're using the original power cord and haven't installed this support, there's a genuine risk of accidentally forcing the power connector into reverse - it's absolutely essential to have one.