Replica of Grenadier Wizard's Room 2009C Miniature

prusaprinters

This is a replica of figure C from the box "Wizard's Room", number 2009 from Grenadier (see http://www.dndlead.com/grenadier/ADandD/2009.jpg ) Reproduced using https://www.thingiverse.com/thing:1762299 "Work desk w/ components" This shipped as a 2-piece model. Since I did not glue the 2 pieces together, I was able to scan them separately, which was good because I don't know how I would have imaged the underside of the table otherwise. Two separate model files are included. They are sized slightly differently, so pay attention to the printing instructions. Note that I had considerable difficulty printing this model, with Cura disconnecting from the printer, printer stopping midprint, failing to extrude filament properly, etc. I suspect that the wizard has put a curse on the table. You have been warned! Print Settings Printer Brand: Monoprice Printer: Maker Ultimate Rafts: Yes Supports: Yes Resolution: 0.1mm Infill: 25% Filament: eryone PLA white Notes: I had to use a raft for the table top, otherwise it warped. Print at 185% to match original, set Z = -0.2mm Table legs require supports. Print at 195% to match original. My printing fellow suggests printing the legs upside down, and sunk slightly into the build plate (perhaps -0.2mm) to make the surface flat, so the table top rests on it smoothly. Sounds good to me! Category: Scans & Replicas