Replica of Grenadier Dwellers Below 2012B Miniature

prusaprinters

<p>This is a replica of figure B from the box "Dwellers Below", number 2012 from Grenadier</p> <p>(see <a href="http://www.cs.cmu.edu/~tpope/sol/grenadier/images/2012.jpg">http://www.cs.cmu.edu/~tpope/sol/grenadier/images/2012.jpg</a> )</p> <p>Reproduced using <a href="https://www.thingiverse.com/thing:1762299">https://www.thingiverse.com/thing:1762299</a></p> <p>The Intellect Devourer first appeared in the AD&amp;D Monster Manual (1977). It was later "revealed" that they were created by the Illithids.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Monoprice</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Maker Ultimate</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>0.1mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>25%</p></div> <p><strong>Filament:</strong> GizmoDorks PLA grey</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>I printed mine at 150%, but that is clearly too large to match the size of the original.<br/> I recommend printing at 130% if you want to match the original figure. However, since the creature is listed as "small" in most editions of the game, you may want to print it smaller. <p>I also used supports, but depending on your printer they may not be needed.</p> </p></div></p></p></p> Category: Scans & Replicas