Replacment Stereo Skull Knob Volume 2in

pinshape

This is a replacement volume control knob for Denon stereos and other similar models, featuring a 2-inch round design with an optional Skull attachment that can be added at will. To engage the Skull feature, simply rotate it to face flat against the backside of the unit and secure in place. The same applies to the main knob itself, which must be positioned with its flat side facing downwards on a stable surface. A special thank you goes out to Dr. Cal Coopmans for providing the initial inspiration behind this unique print design, which proved to be an enjoyable challenge to bring to life! Printer: Monoprice Select 3D Rafts: None Required Supports: Not Necessary Resolution: .1 Millimeters Infill: 20 Percent Notes: Easy print job completed in approximately two hours. Post-Printing Procedures: To achieve a smooth finish, apply three coats of clear Emanel Fingernail polish to the interior surface of the knob where it interfaces with the stereo unit. Allow each coat to dry completely before applying additional layers, resulting in a glassy sheen that perfectly complements the overall aesthetic of the design.