Replacement top half umbrella bracket for CowboyStudio Swivel Tilt Bracket

thingiverse

This is a replacement part for the umbrella swivel bracket manufactured by CowboyStudio and sold on this Amazon page: https://www.amazon.com/CowboyStudio-Umbrella-Bracket-Swivel-E580EX/dp/B0034WR71G/. For both identical brackets I own, the bolt on top broke loose and started spinning freely. I designed this replacement part to utilize existing hardware plus a standard 1/4 inch 20 bolt approximately 1/2 inch long. I printed these with the bolt face down so that the two arms stick up. Notably, it printed well without any supports. It turned out fine with line supports as well. I think I used .15mm layer height but this shouldn't matter much. It feels just as sturdy if not more sturdy than the original bracket. And if this one breaks, I'll simply print another one.