Replacement Thumbsticks for DJI RC-N1 Controller (Mini 2, Mavic 3, Air 2 and Similar)

thingiverse

***WARNING*** Do not over tighten these thumbsticks into the controller. It is possible to damage your controller by attempting to force the thumbsticks in. Use caution when using these, especially for the first time. Overtightening can cause the hub it screws into to break loose and spin, on mine it was still functional but if it is at the incorrect angle, some directions may not be usable causing loss of control of your aircraft. USE EXTREME CAUTION INSTALLING THESE TEMPORARY REPLACEMENTS. I AM NOT RESPONSIBLE FOR DAMAGE THAT OCCOURS TO YOUR CONTROLLER ***WARNING*** These are replacement thumbsticks for the DJI RC-N1 controller used by the Mini 2, Mavic 3, the Air 2 and Air 2S, and similar drones. It will only fit the controller in the pictures. This was designed to be as OEM style as possible, with the original style and a more rounded one that won't be so hard on your thumbs, but may not be as controllable. When the threads are cut properly with an M4 nut, it should thread in like normal, and the bottom pocket should hold it just like the ones that came with the controller originally. I printed the original style with a raft and supports, but the thumb-friendly version should print fine without either. This is intended as a temporary solution, as stated above it can damage the controller if you are not careful. I used an M4 Nut to cut the threads before threading it into the controller. ABSOLUTELY DO NOT USE THE CONTROLLER ITSELF TO CUT THE THREADS, YOU WILL DAMAGE YOUR CONTROLLER.