Replacement speaker yolk (Left side) for Sony MDR-V300 Headphones

thingiverse

This was one of the first things I set out to print on my (then brand new) 3D Printer, Bukito. The project involved creating a replacement part for a broken piece on my headphones. I managed to achieve good results using a layer height of 0.2mm and automatically generated supports from Cura. On the other hand, a 0.4mm layer height resulted in too much drooping, even with the support structure intact. In some cases, additional processing may be required on the outside of the part using cutting pliers and/or a blade, while a drill bit might come in handy to clean up the pin hub area. Nonetheless, it prints remarkably well overall. By the way, note that this is listed as the left-side yoke; however, simply flipping the design within your software would allow you to produce the right-side part if that's what you need.