Replacement leg for Logitech K120 keyboard

thingiverse

I broke the keg on my Logitech K120 keyboard, so I came up with and printed this replacement piece myself. It may fit other Logitech keyboards just fine. Instructions Printing settings don't really matter - I used 0.15 layers (PLA) in Cura with a quarter-inch infill rate and it turned out great on the very first try. The only possible printing problem could be with the posts that are stuck straight up like wings. These might need support to print perfectly, but since all you really want is for this replacement piece to stay put once it's snapped into place, you're good as long as there's enough material holding onto each wing.