Replacement Front Axle Mount for a RC Model Car

myminifactory

When printing this design, you'll need to use support material due to a 2mm height difference from front to rear. This part replaced one that broke, so instead of buying a new one, I was able to create a replacement using Open SCAD and a 3D printer. That repair allowed me to put my Arduino Bluetooth controlled model car back on its wheels and finish it. It was printed with support material because its about 2mm higher at the front than the back. Its thickness is around 5mm, I kept the support material in place to provide extra strength and stiffness. The time taken to print was roughly 7 minutes.