Replacement Feet for Transformers Earthrise Ironhide 3D print model

cgtrader

DescriptionWhen word came that WFC Earthrise would see our favorite bots once again take on their earth alternate modes, there was much excitement indeed! While mostly expecting a lot of them to undergo some re-tooling to get the forms just right, it was a little unfortunate the the re-designs for Ironhide and Ratchet came out slightly subpar with their earlier WFC Sieve Cybertronian feet simply sticking out of the back. So here we go - replacement feet for our beloved pair of bots! These replace the Cybertronian feet to give a more accurate back-of-van look for Ironhide here in his alt mode. Took a couple of rounds of to-and-fro to get as close as possible. Due to van alt mode having a curved surface, these feet do not stand perfectly flat on the ground, but do have various design elements which should help balance it out somewhat. And good 'ol Ironhide can still do kicks, though the underside of his feet are a tad silly :P Now given that this configuration would leave one with a pair of the original feet, it won't do just to have them lying around separately. So also provided in this set is a piece to peg these feet up either to give it a hammer mode, or attached to the rear like a backpack! === Well then, hope this proves useful in improving the rear part of Ironhide (and subsequently Ratchet) for y'all! Enjoy 3d printing this one! =) === This model is not to be uploaded or sold in any form and is intended for personal use only. Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/) Support us on Patreon - https://www.patreon.com/FunbieStudiostransformersearthriseironhideratchetfeetgamestoysgames toys