Replacement feet for Ryobi BT520 Table Saw

thingiverse

Things got a bit rough and I cracked one of the feet on my Table Saw. I measured the one that wasn't cracked, then spent a few minutes modeling it in openscad before sending the print job off. The first print wasn't perfect, but the dimensions were spot on. I put it alongside the original, decided to print another one, and this time did it at a slower speed - it took about 2.5 hours. There are two files now: one that prints a single foot and another that prints two of them. They should work with any printer that's at least 100 wide in the x dimension. Print Settings: Printer: Flashforge Creator Dual Notes: Replacement feet for Ryobi BT520 table saw Based on my tests, 25% fill .3 layer 6 shells 80 print 100 travel No support No raft print duration 90-110 minutes for one foot. about 17 meters of filament for one foot.