Replacement cap for van step floor screw

prusaprinters

<p>This is a 21 mm diameter cap that I designed and printed to replace ones that we lost while working on my sister's 2018 full size Transit van. I explored creating my own tessellation to mimic the textured pattern of the original cap. It worked out pretty well. The Transit van has a large plastic step at the sliding door opening. That step is held down by three or four screws that are then covered with these little pop-off caps.</p> <h3>Print instructions</h3><p><strong>Printer Brand:</strong> Prusa<br/> <strong>Printer:</strong> I3 MK3S<br/> <strong>Rafts:</strong> No<br/> <strong>Supports:</strong> No<br/> <strong>Resolution:</strong> 0.1 mm<br/> <strong>Infill:</strong> 15%<br/> <strong>Filament:</strong> Prusament PETG Black<br/> <strong>Notes:</strong></p> <p>Inverting this in your slicer (pattern face-down) should allow you to print it with no supports. I think I even printed it right-side up without supports. Higher resolution yields better texture results, although the nature of the print is such that just about anything will look good in this application.</p>