Replacement Belt Clip for Baofeng BF-T1

thingiverse

This is an extremely quick and easy print replacement belt clip for the Baofeng BF-T1 miniature Ham Radio. It's compatible with other baofengs that use the same 3mm hole pattern (28mm apart), so it should work just fine with those too. Note that the parts where the screws go into are a bit thicker than normal clips, so the screws only need to be threaded about 1mm into the radio. As far as I can tell, this doesn't cause any issues at all. If you're not so lucky and experience some problems, just send me a message and I'll modify the design for you. UPDATE 10/19/2019 V2 has been uploaded now, featuring countersunk screw holes that allow the clip to sit farther from the radio, reducing strain on the clip from bending outward to fit on a belt. The edge of the holes have been chamfered at about 60 degrees to the vertical to make printing easy without supports. The clip itself is slightly thinner but includes a fillet to increase the strength of the joint.