Replaceable pin Iris Box with shorter compartment.

thingiverse

I was asked by my Home Depot associate if I knew any prints that would showcase the Dremel 3D Idea Builder's capabilities better than chess pieces and dinosaur heads they had been printing. Immediately, emmit's box came to mind. However, while reading the comments on Thingiverse (http://www.thingiverse.com/thing:8402), I noticed mention of weak pins. Therefore, I modified the file to allow them to be printed separately so if a pin inevitably breaks, users can print a replacement pin file easily. This modification also makes assembly easier because users can attach leaves to pins and insert them into place before pressing the ring down on top. A horizontal version of the pin with support was included to reduce its weakness, but unfortunately, it did not come out well. In addition, a smaller version of the container was created to save plastic by cropping out the middle section and merging the top and bottom parts together. Although this resulted in an unusual inner lip where the two parts merged, it's not a problem - just an oddity.