Replace Dog Collar Housing for Extreme Pro Dog Fence System

prusaprinters

You'll need a couple threaded inserts that match the shock prongs. You can reuse the original plastic slip piece that mounts the housing to the collar, you'll just need to open the holes a little bit (I used a dremel but a drill bit or sharp knife could do it). You could also use some threaded inserts to connect the lid to the bottom or just use a correctly sized screw.There is a channel for a rubber belt to be pressed into which should help keep water out. A bead of silicone would work just as well.I printed in ABS and then bathed the parts on acetone to smooth and also add water protection.