ReP_AL Whoop RC

thingiverse

Micro FPV Drone with Camera Holder.\r\nDesigned specifically for 6mm brushed motors, this drone features motor holders slightly oversized to accommodate shrinkage in print. A perfect press fit is achieved on my printer, but if motors are slightly loose, a small piece of tape around the motor will make them tight in the holder.\r\n\r\nFrame Weight: 5-6g\r\n6mmx15mm Brushed Motors with Connectors 59000RPM (approximately 2g per Motor)\r\nTiny Whoop 4-blade Propellers\r\nEachine Beecore F3 EVO Brushed ACRO Flight Control Board (approximately 3g)\r\n200mAh 1S Lipo 15C (approximately 6.4g)\r\nOne Elastic Band for the 1S LiPo Battery\r\nOne Elastic Band for the 1S FPV Camera\r\n1S 3.7V FPV All-in-One Camera (choose a 5g camera)\r\n\r\nTotal Weight: 29-30g Including FPV Camera and Battery\r\n\r\nFlight Time: 4-5 minutes with camera, 5-7 minutes without camera\r\n\r\nAssembly Steps:\r\nSet up the Beecore board using Betaflight.\r\nSolder the LiPo connector to the Beecore board.\r\nPlug motors 1-4 into the Beecore Board. \r\nScrew the Beecore Board to the frame using the camera mount.\r\nSolder the 1S FPV camera to the LiPo +ve and -ve terminals on the Beecore Board.\r\nUse an elastic band to attach the camera to the camera frame (use hot glue if needed for an extra strong fix).\r\nUse an elastic band around the quad for the battery\r\n\r\nGo Flying!!