Rep 2 stand

pinshape

I raised my printer off the desk surface to accommodate a larger filament spool behind it - previously, I had propped it up on old books, but that didn't exactly look great. To solve this issue, I built a stand for my printer. No support or raft is needed when printing this design. Printing at low resolution works perfectly well too. The attached .stl file raises the printer about 100mm from the desk surface. However, it's easy to adjust the stand height using any 3D software you have on hand. To assemble multiple units, you'll need to swap out the existing lower corner hex head bolts with longer versions that are 5mm longer in thread length to secure each stand firmly to your printer.