Renault Zoe MY'21 Wireless Charger Pad

prusaprinters

<p>This is a wireless charging pad that goes in place of the little tray in the centre console of a Renault Zoe MY'21. There used to be a wireless charging pad on the pre-'21 models and it seems to have been removed by Renault.</p><p>You will need to buy a car wireless charging pad like this: <a href="https://www.amazon.co.uk/gp/product/B08TQFCBLR">https://www.amazon.co.uk/gp/product/B08TQFCBLR</a></p><p>Then cut the wireless charging coil out of the silicone with a craft knife.</p><p>You also need some .5-1mm thick adhesive foam sheets, these can be obtained in A4 sheets but some are more grippy than others I have found. The stuff I got from a craft shop was very grippy and the phone doesn't budge at all during driving.</p><p>When printed, add the foam sheet to the smooth surface of the part then cut around the perimiter. Introduce the charging coil to the centre of the printed part so that the coil side sticks to the adhesive foam sheet.</p><p>There is a coil support that can be inserted to butt up to the bottom of the coil pad to support it if needed, some glue holds everything in place.</p><p>When everything is assembled, pull out the existing tray by holding the sides and yanking upwards. The USB cable can then be passed to the back of the centre console and plugs into the rear passenger USB outlet. The tray then clips in place.</p><p>I also used some very thin rubber sheeting on the bottom of the tray to ensure there are no unwanted vibrations.</p>