Remove Before Printing - Dust Cover

prusaprinters

<p>To test out ironing i created this simple "Remove before Printing" tag similar to a Remove before Flight found on many aircraft.</p> <p>Once printed simply insert some spare 1.75mm filament in the hole. The hole is 1.60mm so it's a tight fit. I had success with using a pointed tip and some pliers to slowly and carefully work the filament into the hole then trimmed it to fit.</p> <p>I used Red for the tag and white for the letters, printed in PLA.</p> <h3>Print instructions</h3><p>Print Settings Below.</p> <p>Resolution: 0.20mm Quality<br/> Material: PLA<br/> Filament Profile: Prusament PLA<br/> Filament Brand: Spool 3D Red, Canadian Maker Series White<br/> Ironing: Enabled all top layers<br/> Detect Thin Walls: Enabled<br/> Extra Perimeters: Enabled<br/> Other: Added a colour change at 4.20mm for lettering.<br/> Approximate print time: 90 Minutes<br/> Printer: Prusa MK3S</p> <p>Post printing</p> <p>Cut a segement of 1.75 filament approximately 5-6" in length.<br/> Cut a spear/point on one end.<br/> CAREFULLY insert the pointed end into the printed part using pliers, until around 0.5-0.75" of it is inside or until snug.<br/> Test fit the other end of the filament in the extruder.<br/> Trim end until you get a desired print.</p> <p>Remember to remove before your next print :)</p>