Removable Bed Levelling Probes for Anycubic Kossel Linear

cults3d

This is a technical article about upgrading the firmware on an Anycubic Linear printer to use Marlin 1.1.5, which provides improved features such as Unified Bed Leveling (UBL) and Delta Auto Calibration. Here are some key points from the article: * The author recommends using the newer version 1.1.5 of Marlin firmware instead of the older 1.1.0-RC8. * To configure UBL, you can use the following commands: `G28`, `G29 P1`, `G29 T`, `G29 S1`, `G29 F 10.0`, and `G29 A`. * To perform Delta Auto Calibration, use the command `G33` and save the results to EEPROM using `M500`. * The author notes that there is an issue with Marlin where it raises the effector on Z until it hits the end stops when printing outside the UBL mesh. * The article provides a link to the GitHub repository for the modified firmware, as well as links to the documentation for UBL and Delta Auto Calibration. Some potential next steps could be: * To test the new firmware and configuration settings * To explore further customization of the firmware using the Marlin menu options or other G-code commands * To investigate the issue with printing outside the UBL mesh and see if a solution can be found in later bug-fix releases