RemotePi Supported Raspberry Pi 3 Case

thingiverse

I took Funbarts design for a case that supports the remote PI board sold at http://www.msldigital.com/ and made several modifications. It's not perfect, but I'm publishing it for anyone who wants to customize it for their needs. If I ever reprint it, I'll try to blend the tallest side on the bottom into the curve of the top of the case better. I cut out a hole for the IR receiver (for the version of the board with the attached IR receiver) and didn't have any 2.5 mm screws, so I added pins to hold the PI in place and some tabs for friction to hold the case together. I covered the old power supply input and added a thin cover over the LED, my print is white and the lights shine through it. I also covered the hole for the camera cable (I didn't have a need for it) and had to sand down the pins after printing and enlarged the pin holes with a small screwdriver to get it to snap together.