REMIXED Raise3D N2/N2+ No friction spool holder

thingiverse

I made a remix of https://www.thingiverse.com/thing:1729239 by sylus. Only a few modifications were made to save space, approximately 6 mm, because I encountered trouble closing the door possibly due to the width of the Spool (70mm). Additionally, the initial diameter of the cone was increased for my 55mm internal diameter spool. A small spacer was added to the support to prevent contact between the parts. A centered hole worked better in my opinion. The following items are required: 2 x 608 bearings 1 x M8 x 65 mm screw with a hex head (I purchased an M8x80 screw with a hex head, but it needed to be cut approximately 15mm) 1 x M8 nut (preferably with one nylon stop)