Remixed Pi Camera Mount

prusaprinters

<p><strong>NOTE 1: I don't have a 2.0 Module, so this is tested for the 1.3 module only.</strong></p> <p>I only had a CAD model of a 2.0 module to try with Fusion360 if it fitted in the pegs, and it did, but again, I haven't personally tested it.</p> <p>I'd appreciate if someone with the 2.0 module could test it. I'd do any modification needed.</p> <p><strong>NOTE 2:</strong> Put the anchor point in the opposite side of the ribbon cable slot or<strong>the holes will not align</strong>!</p> <hr/> <p>A no fuss alternative camera holder for <a href="https://www.thingiverse.com/thing:3778486">pbroeder's arm mount</a>. Use it together with <a href="https://www.thingiverse.com/thing:3223979">TeachingTech's flexible webcam mount</a>.</p> <p>The fit of the original model by Modmike is so bad that I decided to make my own, but instead of using complicated fittings, snap-fits, sliding rails or other methods that require a precisely tuned printer... I just put 4 screw holes and that's it. Simple and clean.</p> <p>You'll need 2 or 4<strong>M3-0.5 screws</strong>, depending on how secure do you want it to be. <strong>6 to 8 mm long</strong>. I used 16 mm long because that's what I have and I don't mind them protruding from the back. I might get the Dremel tool out and cut them at some point...</p> <p><strong>I've provided two anchor points, one in the back piece and one in the front piece:</strong></p> <p>You'll need a Back piece with the anchor point and a front without it.</p> <p>Or the back piece without anchor point and a front with it.</p> <p>Or, hell, print both anchor points. Who am I to stop you?!</p> <hr/> <p><strong>Post some Makes if you print this!</strong> <strong>Like and comment if you ended up using this design!</strong></p> <p>Thank you han have fun. :)</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 3</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p><strong>Filament:</strong></p> Generic PLA <p>The one you like most</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>You'll need supports fir the anchor point in the file "Front piece with support.stl"</p></div> </p></p> Category: 3D Printer Accessories