Remixed helical gear vases with base using 608 bearings

prusaprinters

I partially printed the original design and decided I wanted to remix to make them spin a bit more easily.  In keeping with the vase mode print, I had to bump up to 34 bottom layers with a .32 layer height to fit the bearing in.  Uses around 90g filament per vase.Bearing recess is 8mm tall, I added another 2mm to that to figure out roughly where to set my layer count to that'd give it a little support above.  Still around a 4 hour print at 100%, up from the 2-3 hours of the original model.Adjusted base to have a slight step to support the bearings and down to 7.75mm diameter for the bearings to be an easy fit.Vase settings:.32 layer height, .2 first layer230c w/ hardened tool steel 0.6mm nozzle0.8mm walls80mm/s perimetersInland Silk Lime and Silk Copper filamentBase printed at .24 layer height, 15% grid infill, using Inland Twinkling Black.  First layer slow, at 15mm/s, this stuff does not like to stick on my PC build plate.  Printed on CR10s pro w/ whambam PC flex plate, Microswiss M2 0.6 nozzle.