remix- XChange Tool Holder

thingiverse

These is a remix of the XChange Tool Holder by zcohen, which was a remix of my original. His was much better at holding the x-change, I was still worried about them being knocked out when I mounted them on my bench. I added a safety belt so they will stay put until removed. The clasp I found here https://www.prusaprinters.org/prints/44243 The complete assembly consists of: 1 - x-change w strap 1 - x-change base 2 - clamp 1 - quick_release_male.stl (from the Prusa printer link) 1- quick_release_female.stl 3/8 inch elastic band material I used 3mm brass heat set inserts for the belt attachments. This makes it easy to adjust the strap length if needed. I used the x-change base under the x=change w strap. This provides clearance for the elastic material. The quick release pair works well, but if your first layer is off, you may not be able to open them. It took me a few tries to get them working well, but when I did they are great.