Remix: Speaker Stand Launch Pad

prusaprinters

I wanted to create an easy to use and set up launch pad for a recent launch. I needed two pads for NSL 2022 at Dalzell, SC. I found wardy89's pad design and felt I could make it better. I wanted right angle rail adaptors to make sure they would allow the rail to go to 90 degrees and rest on the top of the speaker stand. I also wanted to add a 20mm and 1010 rail to the mini and micro rails. This design was near perfect so I adapted it to fit my needs. It has the same design to mount to the speaker stand, but ti adds the 90 degree and additional rails to the already approved design by wards. It continues to be quick and easy to change between rail's or lower a rail to easily load a rocket. I have achieved this by using drop nose pins to secure the rail to the stand, they can be very easily and quickly removed to swap rails or the top pin can be removed to pivot the rail down for loading a rocket. There are rail mounts for 1010. 20mm, MakerBeam and MakerBeam XL The clamp is designed round a light stand with diameter of 35mm (1.5"). Additional Hardware: for the clamps: 4x 15-20mm M6 Bolts 4x M6 Nuts (I used Nyloc's) 2x 5mm M3 Machine screw 2x M3 Bolt (i used Nyloc's) 2x 6mmx30mm or longer drop nose pin. For the MakerBeam XL Rail: 4x 5mm M3 Machine screws 4x M3 t-slot nuts For the MakerBeam Rail: 2x MakerBeam square headed bolts 2x M3 t-slot nuts For the 20mm rail: 4x 8mm M3 Machine screws 4x M3 t-slot nuts For the 1010 rail: 4x 8mm M3 Machine screws 4x M3 t-slot nuts Print Settings Printer Brand: Prusa Printer: i3 MK3 Rafts: No Supports: Yes Resolution: 0.2 Infill: 25% Filament: 3DXTECH PC ABS blend Black and grey Notes: I use this filament. https://www.amazon.com/3DX-3DXMAX-PC-ABS-Black-1-75mm/dp/B0844VP927?crid=2Q5YSV3CH4RW4&keywords=pc+abs+filament&qid=1657236203&sprefix=pc+abs+fialement,aps,71&sr=8-4&linkCode=sl1&tag=3dprintblog-20&linkId=94833e15dc95fed104024fa140149f00&language=en_US&ref_=as_li_ss_tl Category: Hobby