Remix: Snowboard Vice for Ender 3

thingiverse

SNOWBOARD VICE ==================== This is a Remix of 0161design design wich is a remix of 4numen design of a Snowboard Vice. __Parts needed:__ --------------------- - two M10x100 screws (or something around that length) - two M10 Nuts __Printing:__ Print everything of the folowing two times: -Snowboard Vice 210x210.stl -KnaufM10.stl -Clamp_Cap_M10.stl The KnaufM10 is a pressfit,(heat up your screw and press it in, so it wont slip of later) If you want it to fit loosely, scale it up by like 5%) I recommend to edit your mesh to a local infill of 100% around the nut insert in the SnowboardVice. Not necessary, but recommended. __Design Ideas:__ --------------------- Its pretty much the same design as 0161design and 4numen did, but smaller in width, so that it fits on an Ender3 or ther Printer with a bed space of less than 210mmx210mm. Its pretty much a copy of the Snowboard vice you can buy for around 100 bucks. __How to install:__ --------------------- Put the two M10 nuts in the slot at the bottom, srew the screw in, witch the knob attached to the head for easier fastening and the clamp cap at the end of the screw to not ruin your table. __Trivia:__ --------------------- Insert a change filament Gcode in after the first 5 layers and before the last 5 layer for a nice looking two color design. If you want to edit this design, check out the *.CATPart and the *.stp files.