Remix Snap-on Filament Guide

thingiverse

Remix of https://www.thingiverse.com/thing:4379961 by Ragpuss1961 The arm is shorter (closer to the spool) to line up better with my extruders. The width for the box was brought in to better fit the width of the roller with a little play. Plus 1 side (the bottom when printing) is capped instead of all the way through. I printed with tree supports touching build-plate. By capping off the hole, it didn't try to place supports through it. And the pin was shortened to match the new width of the holder. A little bit sticks out - just enough to grab if I need to pull it out. With the thinner holder you can't easily get to the pin otherwise. I put a tiny dab of hot glue in the capped hole as I push the pin in to hold it from working it's way out. Last the wheel was put together and printed as 1 piece. Print with Tree supports for wheel and holder. I printed the pins on a raft - without it, it broke free from the bed.