Remix of the Hub90mm + NutFlat with 3 sizes filament rings included and more

thingiverse

Hello guys, First of all, I want to thank Vincent for his fantastic work. However, I encountered a small issue with all spools not sitting properly in the middle of the hub and if it's not completely centered, the spool runs erratically so also acting strangely with the springs. So, I tried to find a solution to resolve this problem, I measured about 24 spools I had here and found out that there are three different center sizes on my spools. Therefore, I created these remixes, it's my first remix since I got my 3D printer. It's V1 version, yes, I know the outer rings aren't perfectly round but that was exactly how I wanted them to be designed. If the centers are a bit off, you can still get them in the center and they hold much better, I tested this myself and it works flawlessly. This design also makes the hub stronger and the size and height of the nut remain the same. I added a single adapter v1.0 that slides over the hub or the nut flat so you don't need to reprint the nut or hub. (this one needs support) I added v1.1 richard's hub ring now the adapter goes smoothly over the hub axis. I also added a new version of the adapter with a separated screw-thread for Vincent's hub only, for even more stability. The nut and non-Vincent versions work perfectly fine with this version of the hub. https://www.thingiverse.com/thing:3425043