Remix of DIY battery powered power supply

thingiverse

I required a portable 12v power source for my Rolling Plotter design and Pat Kalahar's Instructable looked ideal, but I needed it to mount on V-Slot. I reworked the design in Fusion 360, adding a mounting bracket that matched my project requirements. The display panel was reoriented 180 degrees from its original position since I'm mounting this in a different orientation. Section cuts with the battery and panel installed appear to fit with this change. I haven't printed it yet, but I wanted to upload it since it's fresh on my mind. I overlaid the STL files of the original design and this one in OpenSCAD, and they seem good. This version does need a fair amount of support to print with all its overhangs. It looks like a 4 hour print, so I'll wait until closer to my parts delivery before printing it in case I change my mind about which design to use. After finishing this rework, I found another design that also has a USB plug. I ordered the USB and Bluetooth module, so I might add a place to put the USB board. Here's the build log for my Rolling Plotter: https://openbuilds.com/builds/a-rolling-plotter.9207/