Remix of Cyberzoid's Window Blind Stepper Mount

thingiverse

I found that Cyperzoid's stepper mount didn't fit in the small gap above my window blinds enclosure, and there was also a metal part inside the enclosure that was obstructing the left clip. I gave the clips a bigger radius, made the ends thinner, and changed the angle a bit. I also offset the left clip so it wouldn't be blocked by the metal part in my blinds. Finally, I changed the motor adapter to work with the "hook and eye" style shaft. You will need to print the left clip (the offset one) with supports. I found that Cura's tree supports worked quite nicely with my Ender 3. Make sure the tip of the mount has a support close to the edge, as the printhead does a sharp turn here and will leave a large blob (or completely ruin the print) if it is not supported. The motor shaft adapter may be too long/short, so I recommend printing 2 or 3 of them with different Z scale factors. They are a tight fit, so if you find that the holes are too small you can increase the X/Y scale factor by 5-10% . I included the .ipt files in case you need to make some changes.