Remix of CR10 Leveling Knob by Oggie

thingiverse

The new version is perfect. Finally. Just made some and put them on. They fit just right and tight. I suggest using at least five top layers so the letters are clearer. Did mine at 0.16, 203C, 62C bed, around 50-55 speed, 20 %infill. Supports are not necessary, but if you get some small stringing, I suggest cutting it away with a scalpel which gives nicer edges. Use Tacblades easy leveling: https://www.youtube.com/watch?v=gkZUAyTxU1Q Find Tacblades here on thingiverse for other good mods too. Edit: 10.01.18 Just uploaded a new version. The previous one had a weird problem (what a surprise...) that was undetected by meshmixer and ideamaker fixing options. It looked ok but it would print badly. This new version is fixed and it prints right. After a long, tortuous, and titanic struggle I finally managed to remix this knob so it fits 17.5mm leveling wheels on my CR10. This included a lightning storm power failure just as I finished the new improved model in Fusion and tried to save it. And then when I did it again, just before saving, Fusion crashed again... And that was just in one evening. Now, the new parametric model adjustments have been made and it is ready. Thanks to Oggie. If the dimensions don't fit your wheels you can adjust them in your slicer, but be sure not to make the overall diameter reach 78mm because that will make it scrape against the printer gantry with the two knobs in the back. Or you can download the original Oggie knob. I just changed the visual design of the center a little bit so its clearer its a remix and made the whole thing a bit thicker, more or less just mucking around at the end.