Remix of Buddha Night Light

prusaprinters

<p>I really liked the Buddha night light but was a bit disappointed when I printed it out and put a light in to to discover that it only lit up the bottom half of the model. So I took the model into Meshmixer and hollowed out the entire model (using 2mm thickness walls) and removed the original interior hollow channel created for the tealight. I also reduced the size of the tealight hole slightly (from 40mm to 39mm) to make the light fit a bit tighter. I also removed a little of the base because it appeared to S3D that it was not completely flat.</p> <p>I printed this using PRILINE PLA White.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>i3 MK3</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>0.15mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>10%</p></div> <p><strong>Notes:</strong></p> <p>I used Simplify3D to generate interior supports (4mm). There is no need for external supports. I then used needle-nose pliers to remove the supports from inside the model using the tealight hole in the bottom.</p> </p></p></p> Category: Art