Remix of Arduino case for Adafruit PowerBoost 500 shield and Ultimate GPS

thingiverse

Here is the text: Remix of Arduino case to hold my GPS logger project consists of an Arduino Uno, Adafruit PowerBoost 500 shield paired with a li-po battery, and the ultimate GPS shield itself. I moved the case outward by 5mm to accommodate the two shields better. The USB/Power holes were tweaked to enable smoother sliding of both shields into place. I employed 35mm M3 screws coupled with spacers to hold everything in place. Ideally, however, it is recommended to use 30mm-32mm M3 screws. A lid was added to the remix and it now provides a decent friction fit; some further tweaking could potentially improve its performance. The project specifications dictate printing at .3mm resolution and achieving an infill percentage of 34%.