Remix model test "kickstarter-autodesk-3d-master" that eliminates unnecessary difficulties by conucting the test

myminifactory

This test is compelling in demonstrating the printer's capabilities. The test was conducted twice to achieve comprehensive results. Test number 1 was performed with the following parameters: 1. Material - ABS, unpainted from # 3DPlast. 2. Nozzle diameter is precisely set at 0.3 mm. 3. Layer height is carefully adjusted to 100 μm. 4. Printing temperature is consistently maintained at 240 degrees C. 5. Default speed is established at 40 mm/s. 6. Outer perimeter speed is optimized at 20 mm/s. Based on the outcomes, a score of 27 out of 30 was achieved. During the test, an interesting phenomenon related to the construction of test platform 2 (the accuracy of plastic feed) became apparent, affecting printing but not impacting the evaluation of the test. The model's features were found to hinder the S3D Slicer's ability to properly process the platform base, resulting in perimeter sagging, especially when printing with relatively thin layers, and reset of some supporting surface loops formed on it. To simplify the test process, necessary adjustments were made to the model geometry. After installing a nozzle with diameters of 0.4 mm and increasing layer height to 200 μm, another test was conducted (number 2). Based on these results, an estimate of 25.5 out of 30 was obtained. References: Printed on 3D Printer Lad-1.0: