REMIX: Mass Effect M-6 Carnifex by jessthemullet | SPLIT MAIN BODY

thingiverse

I printed [jessthemullet's][1] updated [Carnifex][2] which had the main body split into 4 parts with room for installing lights and magnets. However, I wanted to print a version that had a solid main body. I am printing on the Ender 3 V2, so the main body from [his older version][3] was way too big for my bed. As such, I have split the main body into two and uploaded it here as a remix. UPDATE: I noticed a few of the buttons were missing from the originals, so I added them back in. This change cut my print time in half and eliminated the need to sand, fill, and glue 4 pieces together. I was able to print vertically to print without bad surfaces and barely had to sand it. This remix is ONLY the main body. The rest of the parts can be found at either of these: old- https://www.thingiverse.com/thing:304122 updated- https://www.thingiverse.com/thing:455678 I contacted Jess on Instagram and he said that the rest of the parts should be interchangeable. I printed all the other parts from the updated version, but if I choose to use this solid main body from this remix, then I have to use the trigger from the old version. I strongly recommend printing this vertically, with the bottom sides (the sides where the handle, triggers, etc. connect) down. Note that Jess's original STLs for the main body were upside-down. I have flipped them to my recommended orientation. [1]: https://www.thingiverse.com/jessthemullet/designs [2]: https://www.thingiverse.com/thing:455678 [3]: https://www.thingiverse.com/thing:304122