(Remix) Commodore 1702 monitor door

thingiverse

This is a remix of the "Commodore 1702 monitor door" by SkaBoyTD. I made numerous tweaks and modifications to his original design. Upon examining my Commodore 1702 monitor (NTSC), I noticed subtle differences in placement and sizing from his design, necessitating adjustments. The changes to the original include a revamped middle "bridge" piece, which I replaced with an elongated and reinforced U-shaped bar. In my test print, it fit perfectly, requiring only a press-fit into both halves without needing glue (though gluing is recommended for long-term use). Another change was incorporating small 0.4-sized holes in the tabs; although this may seem counterintuitive, these holes are crucial as they allow most slicers to print successfully, preventing the software from treating them like walls and rendering 100% infill unnecessary. I also decreased the right side by 1mm for a better fit with my 1702 monitor. Moreover, I made the click lock notch double wide due to my door lock bump being in a slightly different location than SkaBoyTD's design. If everything prints correctly, you should require minimal sanding, and the middle "door center" part will press-fit snugly into both halves without any issues.