Remix - 9V battery safety cover

thingiverse

Improvements were made to ecodad's clips by increasing the diameter of the rings for better retention, adding a tab for easier removal if stuck, and creating small holes for probe testing without removing covers. The risk of shorting is minimized as only small objects can enter. Gratitude was expressed for sharing the .123dx file. Further updates include adding a ring to the small post for better snap-in, widening test holes for 2mm meter probes, strengthening the small post due to a snapped off incident, and providing four versions of files as .stl in addition to the edited .123dx file. Printing instructions are given at 2 shells, 100% fill, 0.2mm layer height for solid and small prints within 6 minutes.